The parameters below is whats needed to communicate with your VFD through rs485/serialport only. Do a google search for parameters for new set up on VFD/spindle.


Parameter Value Description 

PD001>>>>>>>>>>>>> 02 Enable commands on port rs485 
PD002>>>>>>>>>>>>> 02 Enable speed control on port rs485 
PD004 >>>>>>>>>>>>> The Base frequency of your motor (see motor plate) 
PD023>>>>>>>>>>>>> 01 Enable reverse rotation (only if you want to run CCW) 
PD163>>>>>>>>>>>>> 1 Vfd address 
PD164 >>>>>>>>>>>>>1 Line Speed(1 for 9600 bauds) This setting must match with HYPLUGIN
PD165>>>>>>>>>>>>> 3  ( 8N1 RTU) 

1. Put HYPLUGIN.dll in "UCCNC/Plugin" folder.

2. Start UCCNC and goto CONFIGURATION / GENERAL SETTINGS / Configure plugins.

3. Locate HYPLUGIN11 and check boxes "Call startup" and "Enabled" .

4. Retart UCCNC.

5.Go  to CONFIGURATION / GENERAL SETTINGS / Configure plugins / HYPLUGIN11 / Configure.

6. Press Config button, when window appears press "Availible Ports" button, choose your Port and Baudrate(Baudrate must match VFD settings).

7. Fill in your Min RPM,  Max RPM and  Max Frequency without comma or decimal. Example: For typical chinese spindle, 6000 for min rpm,  24000  for max RPM and 400  for frequency.

8. Press "Save Port" button for com set up and "Save Settings" button for motor/spinde set up, doesen't matter the order as long both pressed after text fields filled in.

9. Retart UCCNC.

10. If using pulley system the Plugin will calculate ratio with your inputted  max rpm and max frequency for motor/spindle. You can change pulley within UCCNC like you normally would with M215 PX.

When using the M215 PX method you will get a window with new max RPM, use this max RPM for pulley set up in UCCNC.

                                                                                                                   Important Notes!!!



1. If using a typical chinese spindle(400hz/24000rpm) make sure in  "CONFIGURATION / AXIS SETUP / SPINDLE"   pulleys are UNCHECKED in UCCNC Spindle setup. 

2. Make sure in UCCNC settings "CONFIGURATION / AXIS SETUP / SPINDLE"  PWM spindle is checked.

                                                                                     
                                                                                                                 Additional Features!!!

1. Out Amps displays the spindle/motor amp usage, this requires the user to create a new field on screen. To do this simply make a copy of Sact field in UCCNC "screen edit" and place whereever you like. You may want to change text color from white if using default screen, you also need to change the labelnumber to match what was inputted in HYPLUGIN configure setup.

To Use:

Check Amp box in HYPLUGIN configure setup and input a labelnumber of created field.

2. RPM Only.... check this box only if you DON'T want the plugin to have any control of spindle/motor's on and off.







